No. Materials needed and labor required to build power fence are both significantly less than for barbed wire – up to $1,000 per mile less.

Isn’t power fence intended to be a temporary fence?

High tensile power fence is every bit as permanent as barbed wire.

Is power fence safe for horses?

An equine power fence is one of the safest and most effective fences and training tools you can use for horses. It teaches horses to respect all fences, and when properly designed, it will keep dogs and other unwanted animals out of your horse pasture.

Deer, elk and antelope tear up barbed and net wire fences. Why should I consider a power fence?

Deer, elk and antelope will always win the battle with a traditional fence – it’s a physical barrier that doesn’t match the strength of the wildlife involved. The proper design and post spacing of a power fence allows for a “flexible“ fence, which can take the abuse of the wildlife yet remain intact and control livestock.

What’s the most common cause of power fence failures?

80% of all power fence problems can be traced to inadequate grounding. Your grounding system must be perfect for your fence to perform at its best. After all, it’s half the system.

What does Gallagher recommend for grounding a permanent power fence system?

A minimum of three, six-foot long, galvanized steel ground rods, spaced at least 10 feet apart, and joined with one continuous galvanized wire clamped to the rods.

Can I use copper ground rods?

No. Copper ground rods are not recommended since copper will react with any galvanized steel through electrolysis, and corrode the connection. Gallagher uses only galvanized steel components to avoid this problem.

My animals don’t respect power fences when the soil dries out. What can I do?

You have probably used an all-hot system (all fence wires are charged). Gallagher recommends all-hot systems only in areas with 35 inches or more of moisture per year. A hot/ground system might be a better choice. Make the top wire of your fence hot, then the next one down a ground wire, and so on. Tie the ground wires together with galvanized wire and clamps at the ends, then connect this to the ground rods, and the ground terminal of the energizer. This way, you carry the ground system out to the animal, and are not relying on dry soil to make the connection.

How do I carry the hot and ground past all the gates in my fence?

The best way is to bury heavy-duty insulated cable in a trench about 10 inches deep. Make sure it’s rated to 20,000 volts minimum or it may leak current with today’s high-power energizers. Do not staple it to the post. Remember to carry the ground wire across the gateway also, using the same type of cable. It can be buried in the same trench as the hot cable.

Can I use bare wire to carry the ground under my gates?

No. Use heavy-duty insulated cable for the ground wire. Even good Class III galvanized wire will corrode rapidly when in contact with the soil. Corrosion leads to electricity resistance and soon there is no connection at all.

What should I keep in mind when using high-tensile wire for a permanent power fence?

The two most common errors we see are using too many line posts, and over tensioning the wire. Remember, this isn’t barbed wire. Power fence is a mental barrier for your animals, not a physical one. When using high-tensile wire, it allows for greater line post spacing than conventional wire usually 50 feet as a minimum. Also, don’t over-tighten the wires. You want a flexible system that allows for wildlife impacts, snow loading, etc. Over-building a power fence makes it too rigid, and you lose this benefit. Plus, it costs you more for materials.

Which energizer should I use?

It depends on your situation. Gallagher makes many models with different capabilities. The questions to answer include:

• What animal are you controlling?
  Domestic stock will take less power to control than fencing wildlife out of an area.
  
   
• How big an area do you need to fence?
  Obviously, you will need a bigger energizer to carry adequate power on larger jobs. If there is a large vegetation challenge for the fence you will need more power. Plan now for any additions you may need down the road, too.
  
   
• What power source is available?
  If you can, use a 110 or 220-volt plug-in energizer. If you can’t, there is a wide range of battery and solar units available.
  
   
• Do you need a permanent or portable system?
  If your needs dictate a portable system, one of our solar kits may fit well.

Why does the voltage increase as I move down the fenceline?

The voltage on your fence is greater closer to the end due to what is called the “bounce effect.“ This means that the pulse the energizer has sent down the fence reached the end and is returning back up the fence. It then meets the next pulse coming from the energizer creating a voltage spike or “bounce.“ This really means that your energizer joule rating is more than adequate for your fence load and has a surplus of energy, which is exactly what you want in your system.

Why do some small energizers show higher voltage readings directly out of the energizer than some larger ones?

Voltage merely represents a difference of potential between two electrical points and is only one aspect of overall power. The Joule rating is a true measure of an energizers stored energy or true power.

Is it OK to hook two energizers to the same line to increase power?

No. The components in our energizers are designed for specific voltage and current requirements. Hooking up two or more energizers to the same line will eventually destroy the energizers.

Why is it best to run multiple hot wires instead of just one?

With more wire there is less resistance to current flow in the wires and less of the voltage is dropped in the line itself, which leaves more to shock the animal.

Why is it best to use galvanized grounding rods instead of just driving a large copper pole into the ground since copper is a good conductor?

Bare metals driven into the ground, regardless of their conductivity, are susceptible to oxidation and/or rust. Because power fence energizers emit only a brief, powerful jolt, it is very important that the conductivity of ground rods be maximized to insure that the animal receives a good shock.

Is it OK to hook up a power fence energizer to barbed wire?

No. Animals can become entangled and trapped in the barbed wire, and while the shock emitted by our energizers is not sufficient to kill or seriously wound a farm animal, the stress of being trapped and repeatedly shocked can.